We’re about to show you how to build, setup and operate your own flame show. We’re excited to see what you can do!
First, read the flame show safety page. Safety is always first.
Technical Summary:
We are injecting precisely shaped and positioned gas flows into a flame in order to manipulate the shape and appearance of the flame in specific ways.
We then change those parameters over time (flow rate etc.) to change the temporal appearance of the flame, usually synchronizing to an audio source.
ASIDE: Flames used are paraffin oil/wick based, and the only gas used is air. Everyone asks about using other gases. This would, of course , be possible but it would also be much more dangerous and would require vigorous engineering solutions to assure safety. Do not attempt to use gases other than air.
One more thing before we start:
This hardware design is licensed under the CERN Open Hardware Licence v2 – Permissive (CERN-OHL-P).
You may redistribute and modify this design under the terms of the CERN-OHL-P v2.
A copy of the license is available at: https://ohwr.org/cern_ohl_p_v2.txt
OK, Let’s see how it’s done
—🔥😎🔥—